No Products in the Cart
Clean the bumper and surfaces under the car and the fender wells thoroughly (tar and grease remover is recommended).
Turn the front wheels to gain easier access to the fender liner mounting screws that you will be replacing.
Locate the fender liner mounting pins at the edge of the bumper inside the fender liner and remove the three (3) pins that attach the fender liner to the front bumper starting with the top pin.
Note: the pin is a male/female assembly. The male piece can be pried loose from the female piece using a flat blade screwdriver. Insert the blade of the screwdriver in the slot at the edge of the pin and twist the screwdriver causing the pin to come free of the female piece. After removing the male piece, the female piece can be easily removed.
After removing the retaining pins, spread the fender liner to gain access to the bumper and install a J-clip (Nipple side is toward the front of the car) at each of the three holes in the bumper. [The J-clip is designed to go around the edge of the fiberglass bumper and serves as the nut for the screw you will be installing.]. Reposition the fender liner aligning the holes in the liner with the holes in the bumper and install the snap head screws.
Begin the mask installation by fastening the snaps on one end of the mask to the screws just installed on the edge of the bumper.
Stretch the mask across the front of the bumper and attach to the other side of the car. Note: the tension in the mask is normal and important to the overall performance of the product.
Open the hood on the car and remove ONLY the male portion of the four (4) push pins located just behind the weather strip and Install a snap head screw stud in its place.(Take care not to over tighten this screw). Pull the top of the mask up and secure the snaps on the mask to the snap head screw just installed.
The NoviStretch™ FBM650M mask is easily secured using snap fasteners integrated into the design.This requires snap-head screws, supplied in the Hardware kit, be installed on the car as described below. The initial installation should require approximately 15 -20 minutes to complete. After setup the mask can be easily installed and removed in just under one minute.
Short handle Philips screwdriver; Flat-Blade Screwdriver
When operating with the mask on the car you will note that the Intake air temperature (IAT) may be higher (20-40 degrees) than under normal operation. This is expected and while it can have a slight effect on engine horsepower output it has no adverse effect on engine operation, oil or coolant temperatures.
Download PDF Guide