Perfomance Protective Covers

FBM650C - Installation Instructions | NoviStretch

NoviStretch™ Front Bumper Mask

Step #1

Clean the bumper and surfaces under the car and the fender wells thoroughly (tar and grease remover is recommended).

Step #2

Turn the front wheels to gain easier access to the fender liner mounting screws that you will be replacing.

Step #3

Locate the three (3) mounting screws around the edge of the liner vent inside the fender liner and remove them. Replace each one as you go with the supplied snap-head screw studs. Repeat this step on the other side of the car.(Fig 3.1 and Fig 3.2)

Step #4

Begin the installation by fastening the snaps on one end of the mask to the screws just installed in the fender liner. (Fig 4.1)

Step #5

Stretch the mask across the front of the bumper and attach to the other side of the car, repeating the addition of the Velcro strip. Note: the tension in the mask is normal and important to the overall performance of the product.

Step #6

Open the hood and remove the two (2) outer most OEM screws located just behind the edge of the bumper cover and install a snap head screw stud. Holding the top of the mask pull it up to the hood opening and fasten the snaps at each corner of the mask to the screws just installed. (Fig 6.1, Fig 6.2 and Fig 6.3)

Step #7

Pull the bottom edge of the mask down under the bumper. The installation is now complete. Optional: If a tighter or altered fit is desired, note the position of the Velcro strip on the bottom/center of the mask. Mark this position on the car and install the mating piece of Velcro to the stretch or tightness desired, taking care to completely clean the mounting surface. Caution: allow 24 hr. cure time before trying to remove the mask after it has been attached. (Fig 7.1)

The NoviStretch™ FBM650C mask is easily secured using snap fasteners integrated into the design. This requires snap-head screws, supplied in the hardware kit, be installed on the car as described below. The initial installation should require approximately 15 minutes to complete. After setup the mask can be easily installed and removed in just under one minute.

The FBM650C is designed for installation on all 6th Generation Camaros.

Tools Required

Short handle Philips screwdriver; #15 Torx head screwdriver

Download PDF Guide