Perfomance Protective Covers

FBM750V – Installation Instructions | NoviStretch

NoviStretch™ Front Bumper Mask

Step #1

Clean the bumper and surfaces under the car and the fender wells thoroughly (tar and grease remover is recommended).

Step #2

Turn the front wheels to gain easier access to the fender liner mounting screws that you will be replacing.

Step #3

Locate the mounting screws at the edge of the bumper inside the fender liner and remove them. Replace each one as you go with the supplied snap-head screw studs. Repeat this step on the other side of the car.

Step #4

Begin the installation by fastening the snaps on one end of the mask to the screws just installed on the edge of the bumper.

Step #5

Stretch the mask across the front of the bumper and attach to the other side of the car. Note: Take extra-care when stretching the mask over and around the Splitter or Spoiler, rough edges and corners on ground fx can damage the mask over repeated installations.

Step #6


Pull the bottom edge of the mask down under the bumper, noting the position of the snaps on the bottom edge of the mask. Replace the screws on the bottom of the bumper that best align with the snaps on the mask with a snap head screw stud. Fasten the snaps on bottom of the mask to the screws just installed on the bottom of the bumper.

Step #7

Locate and slightly loosen the screw holding the corner of the air dam on each side of the car allowing the bottom edge of the mask to go between the bumper and the air dam. NOTE: Do not install mask over the air-dam.

Step #8 & Step #9

Open the hood and remove the plastic covering at each corner to expose the corner edge of the body frame just inside the hood opening. [This piece is held in place with friction clips and is easily removed by prying it loose with your hand]. Repeat this step for the other corner of the mask. Holding the top of the mask pull it up to the hood opening and secure each corner of the mask to the body frame. The plastic cover may then be replaced if desired but is not necessary.

The NoviStretch™ FBM750V mask is easily secured using snap fasteners integrated into the design. This requires snap-head screws, supplied in the hardware kit, be installed on the car as described below. The initial installation should require approximately 15 minutes to complete. After setup the mask can be easily installed and removed in just under one minute.

The FBM750V is designed for installation on all 2014 - 2019 C7 base coupe and convertible model Corvettes.

Tools Required

Short handle Philips screwdriver; #15 Torx head screwdriver; socket wrench; 7mm socket

Download PDF Guide