LC100HD – Installation Instructions

The NoviStretch™ LC100HD lid covers are a stretch-fit protective cover designed to slip over the top of all Harley-Davidson hard bags.

Download PDF Guide

Installing your new
NoviStretch™ Lid Covers

Step #1

Clean the Hard Bag Lid thoroughly (tar and grease remover is recommended).

Step #2

With the top of the saddlebag open position the lid cover over one end of the top and then stretch to secure the cover over the other end.

Note: this is a tight fit but the material will stretch to allow the cover to pass over the housing and ensure a snug, contoured fit.

Step #3

Arrange the material by adjusting as necessary to position the cover smoothly over the housing.

Note: the hinge side of the lid cover may be positioned by working the material slightly “back & forth” to tuck underneath the hinge. As well, the cover can be installed over the latch handle without interfering with its operation.

Download PDF Guide

Tools Required

No Tools Required.

Cleaning and Care Instructions

  • The mask can be cleaned by rinsing in water to remove any dirt or debris then squeezing the water out and let air-dry. Wash (by hand) only as necessary. Use a concentrated soap solution on areas of the mask that may be particularly dirty.
  • Always ensure areas covered by the covers are clean and free of sand and grit before installing the mask.